automate till end

[agus]

you know how when you are doing a Latch automation... when you stop, the setting jumps to a previous null point. How can you set the automation to write the last location until the end of the project? Is there a quick key on PC?

[Chris Lambrechts]

try the following while writing automation :
CTL/CLUTCH (most left/low button on PC) + "go to end of session (above transport : > )
explained on page 174 of the manual)

hope this helps .....


Chris

[agus]

Thanks Chris... I'll give it a try. Manuals... who needs them when you've got the DUC. Thanks again