Profire 2626 analog INputs 3-8 Don't show up

[norton]

I'm running a profire 2626 with mpowered 8.0 and protools doesn't recognize inputs 3-8.

The 2626 software mixer sees signal and the chain seems to be set up correctly. However I'm only able to route signal from analog 1 and 2 and spdif in the input select pane in Protools.

Any ideas???

thanks

[clausiii]

Check the I/O Setup in PT and if there aren´t all ins and outs, try the "default" button. Maybe you opened a session, which was created with another interface?

[Anotherstate]

Hi Guys ..
Do you have those (TOP little buttons) on the M-Audio MIXER, set to the right (ins) on the unit and PT session?

Question: (for me)
I'm just now hooking my 2626 to a Focusrite ISA 828 ( 8 channels ADAT)
I have the Light-pipe into the 2626 A (IN) and all is working.
1-6 Analog and then 9-16 ADAT (A -IN) = 16 channels w/audio in headphones. Not getting OUTPUT from the session after recording. Strange??
The signal flow is right in the INPUT CHAIN ... I called M-Audio. I have all 16 channels receiving and hearing all from the headphones on the Profire. And it's recording on the Tracks I'm testing on! But, no OUTPUT to my headphones?? I have the the 2626 to "Mixer Out" ... and int PT Session the same?? Not sure, what I'm obviously missing. Other than that, almost there!

\any suggestions from some one more "in tune w/Profire 2626" Session Flow, please advise. I got the 2626 to get NO latency and still achieve 16 channels for Live Performances.

[Anotherstate]

Oh, I noticed the "READ" button for each channel recorded, is "disabled"/ That's strange. Never have I ever seen that. Not like disabling a Plug-in or something, but this is the "Read" button, along with Waveforms, Midi etc...So I thought I'd ask ...Thanks again